HOME PAGE | < Previous | Contents | Next >
Imageable Area Extension Unit Type M19 (D3BR-07)
Installation
Installation
Installation
Paper Transfer Roller".
During PM replacement, do not install the wrong type of roller.
[A]: The standard roller has a gray collar at its end.
[B]: Imageable Area Extension Unit Type M19 does not have a collar on it.
5. Turn ON the main power.
6. Using SRA3 paper, check that a full-bleed halftone image is output, and that the image extends to 315 mm in width.
SP descriptions
SP2-400-001 (Paper Transfer Roller Settings)
Specifies the width of the Paper Transfer Roller. This SP must be set to "1" when Imageable Area Extension Unit Type M19 is installed.
0: Default roller
1: Wide roller
When You Forgot to Change the SP
The following problems occur.
When a change-over was made from a standard roller to the imaging range extension option
(If the SP setting is the normal setting (SRA3 paper not supported), but the optional longer paper transfer roller is installed)
The image cannot be correctly transferred to the SRA3 paper area.
Imageable Area Extension Unit Type M19 (D3BR-07)
The MUSIC/program control pattern adheres to the ends of the paper transfer roller (outside the A3 area), and this can transfer to the underside of printouts.
Real-time process control cannot be performed correctly, and an abnormal image and SC285-00 (MUSIC error) may occur.
When a change-over was made from the imaging range extension option to a standard roller
(If the SP setting is for SRA3, but the paper transfer roller is the normal one (SRA3 paper not supported))
Real-time process control is not performed, and the interval between process controls becomes short.
The waiting time for fusing temperature rise is longer than intended.