HOME PAGE | < Previous | Contents | Next >
External Keyboard Bracket Type M19 (D3BR-10)
Installation
Installation
Installation
2.22 EXTERNAL KEYBOARD BRACKET TYPE M19 (D3BR-10)
2.22.1 ACCESSORY CHECK
No. | Description | Q’ty | Remarks |
1 | Keyboard table bracket | 1 | |
2 | Keyboard stand bracket | 1 | |
3 | Keyboard stand | 2 | |
4 | Screw: M4 x 12 | 2 | |
5 | Screw: M3 x 8 | 4 | |
6 | Screw: M3 x 12 | 1 |
This optional unit is not supplied with a keyboard. Use a commercially available keyboard.
2.22.2 INSTALLATION PROCEDURE
When installing this option, turn OFF the main power and unplug the power cord from the wall socket. If installing without turning OFF the main power, an electric shock or a malfunction may occur.
1. Open the right door, and then remove the small cover [A].
2. Remove the screw and connector, and then remove the front upper cover [A].
External Keyboard Bracket Type M19 (D3BR-10)
Remember that there is a tab at the positions of the red arrows.
Rotate the operation panel [B] upward to a horizontal position, and then detach the front upper cover [A].
3. Remove the screw [A] on the frame of the machine.
4. Make 3 screw holes in the front upper cover.
Installation
Installation
Installation
External Keyboard Bracket Type M19 (D3BR-10)
5. Reattach the front upper cover to the machine.
6. Attach the keyboard stand bracket [A] on the front upper cover 
x3).
7. Attach the keyboard stand [A] on the keyboard stand bracket 
x4).
8. Place a keyboard on the keyboard stand, and then pass the keyboard cable through the hole in the keyboard stand.
External Keyboard Bracket Type M19 (D3BR-10)
9. Remove the rear cover [A].
10. Remove the scanner right cover [A] 
×1)
11. Route the keyboard cable [A] along the right side of the scanner unit as shown below.
12. Route the keyboard cable along the rear side of the scanner unit 
x1).
Adjust the keyboard cable by making loops if the keyboard cable has too much slack.
Installation
Installation
Installation
External Keyboard Bracket Type M19 (D3BR-10)
13. Remove the cutout [A] in the left rear cover to make a cable hole, and then pass the keyboard cable [B] through it.
14. Connect the keyboard cable to the USB slot.
15. Reattach the scanner right cover, and rear cover.
16. Close the right door.