HOME PAGE | < Previous | Contents | Next >
Installation
Installation
Installation
20. Reattach the controller box cover and the rear cover.
21. Attach the decals [A] [B] to the SPDF.
Adjust SP Settings
1. Turn ON the main power.
2. Set SP4-688-002 (Scan Image Density Adjustment 1-pass DF) to "101".
3. Execute SP4-730-002 (FROM Main Factory Setting Execution ON/OFF).
4. Check the vertical registration for the SPDF.
1. Create an original as shown in the following picture. The large white arrow indicates the direction of feed.
2. Copy the original and make sure that the position of the line [A] is within 0±1mm
SPDF DF3100 (D3B0)
3. If not within the standard, adjust with the SP modes.
SP6-006-001 (ADF Adjustment Side-to-Side Regist: Front) SP6-006-002 (ADF Adjustment Side-to-Side Regist: Rear)
5. Check the horizontal registration for the SPDF.
1. Copy the original and make sure that the position of the line [B] that you wrote on the original (see above) is within 0±2mm.
2. If not within the standard, adjust with the SP modes.
SP6-006-010 (ADF Adjustment L-Edge Regist (1-Pass): Front) SP6-006-011 (ADF Adjustment L-Edge Regist (1-Pass): Rear)
6. Check the skew.
1. Make sure that the difference between both end positions of the line [A] that you wrote on the original (see above) is within 0±2mm.
2. If not within the standard, change the position of the fixing screw [A] to the long hole [B] at the right hinge.
SP descriptions
SP4-688-002 (Scan Image Density Adjustment: 1-pass DF)
Adjusts density difference between Book and ADF. This SP is only for the SPDF models.
SP4-730-002 (FROM Main Factory Setting Execution ON/OFF)
Copies the parameters written in FROM in the SPDF to the engine board in the MFP. This SP is only for the SPDF models.