HOME PAGE | < Previous | Contents | Next >

Troubleshooting for Finishing Options


image


[A]: Proof Tray

[B]: Docking Bracket Screw


After the adjustment, check the side-to-side registration by feeding paper out to the proof tray. If the shift has not been solved, adjust the docking bracket (screw for the docking bracket) slightly again.

6.16.2 FINISHER JOGGER PROBLEM (FOR BOOKLET FINISHER SR3220 (D3B9)

If a paper alignment problem occurs as shown below, do the following procedure to adjust the jogger width.

image

Cause

Depending on the type of paper or the manufacturer, the paper may not be the correct size. In this case, the paper may not align properly even when the jogger is used.

Solution

Adjust the jogger width with SP6-143 (adjustable threshold: -1.5 to +1.5 mm for each paper size).

SP6-143 (Jogger Pos Adj:1K FIN)


Adjust the jogger width to be slightly narrower (approximately -0.5 mm) than the paper width.