Fusing Exit Sensor : Late Jam : Cause Code 019 Ricoh MP C2004 C2504 Service Manual

Fusing Exit Sensor : Late Jam : Cause Code 019

Target Part/SP No.:Fusing Exit Sensor / SP5-803-011 (Duplex Entrance Sensor)

Cause verification	Problem Judgement
Execute an INPUT check when there is no paper at the position of the referenced sensor.	0 :Paper detected
Execute an INPUT check when there is paper at the position of the referenced sensor.	1: Paper not detected

Solution:

 Clean the sensor.

 Reconnect the connector.

 Replace the sensor.

 Replace the Paper Transport IOB.

 Replace the harness.

Target Part/SP No.: Fusing Motor / SP5-804-092 (Fusing Motor: CW: Standard Speed)

Cause verification	Problem Judgement
Turn the referenced motor OFF with OUTPUT check	Drive sound heard
Turn the referenced motor ON with OUTPUT check	Drive sound not heard

Solution:

 Reconnect the connector.

 Replace the motor.

 Replace the Imaging IOB.

 Replace the harness.

Checking paper jam, or paper transfer unit

Check if there is double feeding.	Fan the paper.
Check if the margin of the leading edge of paper is too narrow.	Adjust the margin at the leading edge of paper with SPs.

Troubleshooting