HOME PAGE | < Previous | Contents | Next >
Troubleshooting for Transport/Paper Feeding of the Machine
Replace the sensor.
Replace the Paper Transport IOB.
Replace the harness.
Target Part/SP No.: Duplex Exit Sensor / SP5-803-010
Cause verification | Problem Judgement |
Execute an INPUT check when there is no paper at the position of the referenced sensor. | 0: Paper detected |
Execute an INPUT check when there is paper at the position of the referenced sensor. | 1: Paper not detected |
Solution:
Clean the sensor.
Reconnect the connector.
Replace the sensor.
Replace the Paper Transport IOB.
Replace the harness.
6.15.3 JAM
If the error occurs periodically, do the following steps. If the result is as shown in the "Problem Judgement" column, follow the solutions.
Bypass No Feeding: Cause Code 008
Target Part/SP No.:Bypass/Duplex motor / SP5-804-071 (Duplex Bypass Motor: CW: Standard Speed)
Cause verification | Problem Judgement |
Turn the referenced motor OFF with OUTPUT | Drive sound heard |
Turn the referenced motor ON with OUTPUT | Drive sound not heard |
Solution:
Reconnect the connector.
Replace the motor.
Replace the Paper Transport IOB.
Replace the harness.
Replace the harness.