HOME PAGE | < Previous | Contents | Next >
Troubleshooting for Transport/Paper Feeding of the Machine
6.15 TROUBLESHOOTING FOR TRANSPORT/PAPER FEEDING OF THE MACHINE
6.15.1 CURLED PAPER
Make sure that the following SPs are set to their default values, and keep them at these values at all time.
SP1-113-001 (Curl Correction): Keep at default value of 0 (OFF)
This is because printing productivity drops to about 65 to 80% when this SP is ON. It is not effective in reducing curl on these models.
SP1-115-xxx (Print Target Temp): Keep at default value.
This is because fusing offset may occur when the fusing temperature is reduced. This SP is not effective for improving image quality on these models.
Solution:
Installing the tray heaters for the mainframe paper bank and optional paper banks. (page 2-58 "Anti-Condensation Heater for Paper Feed Trays")
6.15.2 INITIAL JAM
If the error occurs periodically, do the following steps. If the result is as shown in the "Problem Judgement" column, follow the solutions.
Initial Jam: Cause Code 001 / Location Code A
Target Part/SP No.: Transport Sensor (1st Feed Tray) / SP5-803-003 (Transport Sensor 1)
Cause verification | Problem Judgement |
Execute an INPUT check when there is no paper at the position of the referenced sensor. | 0: Paper detected |
Execute an INPUT check when there is paper at the position of the referenced sensor. | 1: Paper not detected |
Solution:
Clean the sensor.
Reconnect the connector.
Replace the sensor.
Replace the Paper Transport IOB.
Replace the harness.