Replacement Ricoh MP C2004 C2504 Service Manual

Replacement

 Do not remove or adjust the pressure adjusting screws [A] when replacing the pressure roller.

 The fusing unit is adjusted in the factory to match the hardness of the pressure roller, so that the nip width will be correct.

 Do not move the pressure roller to another fusing unit.

1. Fusing sleeve belt unit (page 4-134)

2. Pressure roller [A]

Fusing Unit

Replacement and Adjustment

3. Apply the grease (FLUOTRIBO MG GREASE) to the rear shaft of the pressure roller at 5-7mm from the cut edge.

4. Apply the grease (FLUOTRIBO MG GREASE) to the front shaft of the pressure roller at 5-7mm from the C-ring notch.