HOME PAGE | < Previous | Contents | Next >
NFC Card Reader Type M19 (D3BS-21)
Installation
Installation
Installation
2.35.2 INSTALLATION PROCEDURE
When installing this option, turn OFF the main power and unplug the power cord from the wall socket. If installing without turning OFF the main power, an electric shock or a malfunction may occur.
1. Open the right door, and then remove the small cover [A].
2. Remove the screw and the connector, and then remove the front upper cover [A].
Remember that there is a tab at the positions of the red arrows.
Rotate the operation panel [B] upward to a horizontal position, and then detach the front upper cover [A].
3. Remove the original upper cover [A].
NFC Card Reader Type M19 (D3BS-21)
4. Attach the corner cover [A] provided with this option.
Use the screws removed in the previous step.
5. Remove the scanner front cover [A].
6. Remove the operation panel upper cover [A].
7. Remove the operation panel right cover [A].
NFC Card Reader Type M19 (D3BS-21)
Installation
Installation
Installation
8. Thread the USB cable [B] through the notch in the corner cover [A] and attach the ferrite core [C].
Attach the ferrite core 6 cm [A] away from the end of the cable.
By doing so, it becomes easier to put the ferrite core inside the reader cover in step 12.
9. Reattach the front upper cover to the machine.
10. Attach the reader spacer [A].
NFC Card Reader Type M19 (D3BS-21)
11. Attach the sponge cushions [A] to the reader spacer.
12. Connect the card reader and interface cable.
Make sure to turn the USB cable as shown so that it threads through the notch in the spacer [A].
13. Attach the reader cover [A].
Installation
Installation
Installation
NFC Card Reader Type M19 (D3BS-21)
14. Connect the USB cable to the machine’s operation panel connector.
15. Thread the USB cable through the U-shaped groove [A] at the hinge of the operation panel and notch [B] on the cover under the cover.
16. Apply the clamp to fasten the USB cable to the machine.
Make sure that the cable is not loose between the connector and hinge [A] and the hinge and clamp [B].
NFC Card Reader Type M19 (D3BS-21)
17. Tuck in the excess length portion of the USB cable in the space under the scanner.
18. Reattach the removed covers.