HOME PAGE | < Previous | Contents | Next >
2.5 CORNER STAPLING
2.5.1 STACKING AND JOGGING
Booklet Finisher & Finishers (B803/B805/ D373/D374/ D636/D637)
Booklet Finisher & Finishers (B803/B805/ D373/D374/ D636/D637)
Booklet Finisher & Finishers (B803/B805/ D373/D374/ D636/D637)
[A]: Jogger Fence Motor (M15) [B]: Jogger Fences
[C]: Positioning Roller
[D]: Jogger Fence HP Sensor (S15)
[E]: Stapling Edge Pressure Plate Solenoid (SOL4) [F]: Pressure Plate
At the beginning of the job, the jogger fence motor (M15) [A] switches on and moves the jogger fences [B] to the standby position (7.5 mm from the sides of the selected paper size).
When each sheet passes the pre-stack tray exit sensor (S2) and enters the stapling tray:
The jogger fence motor switches on and moves the jogger fences to within 5.5 mm of the sides of the selected paper size.
The positioning roller solenoid (SOL3) switches on for the time prescribed for the paper size. This pushes the positioning roller [C] onto the sheet and pushes it down onto bottom fence. This aligns the edge of the stack.
Next, the jogger fence motor:
Switches on again and moves the jogger fences to within 2.6 mm of the sides of the stack to align the sides of the stack.
Reverses and moves the fences to the standby position (7.5 mm away for the sides) and waits for the next sheet.