HOME PAGE | < Previous | Contents | Next >
2.7 ARDF INSTALLATION (D630)
2.7.1 COMPONENT CHECK
Installation
Installation
Installation
Check the quantity and condition of the accessories against the following list.
No. | Description | Q'ty |
1 | ARDF | 1 |
2 | Attention Decal Sheet – Top Cover | 1 |
3 | Stamp | 1 |
4 | Knob Screw | 2 |
5 | Stud Screw | 2 |
6 | Platen Sheet | 1 |
2.7.2 INSTALLATION PROCEDURE
Unplug the copier power cord before starting the following procedure.
1. Remove the all tapes and shipping retainers.
ARDF Installation (D630)
2. Insert the two stud screws [A] on the top of the machine.
3. Mount the ARDF [A] by aligning the screw keyholes [B] of the ARDF support plate over the stud screws.
4. Slide the ARDF toward the front of the machine.
5. Secure the ARDF with the two knob screws [C].
6. Connect the I/F cable [D] to the machine.
ARDF Installation (D630)
Installation
Installation
Installation
7. Remove two screws [A] from the bottom of the ARDF.
8. Remove all tapes on the ARDF.
9. Place the platen sheet [A] on the exposure glass.
10. Align the rear left corner (of the platen sheet) with the corner [B] on the exposure glass.
11. Close the ARDF.
12. Open the ARDF and check that the platen sheet is correctly attached.
ARDF Installation (D630)
13. Open the ARDF cover [A].
14. Open the feed-in guide plate [B] and feed-out guide plate [C].
15. Install the stamp [D] into the ARDF.
16. Close two guide plates [C] [B].
17. Close the ARDF cover [A].
18. Attach the decal [A] to the top cover as shown. Choose the language you want.
19. Plug in and turn on the main power switch of the machine, and then check the ARDF operation.
20. Make a full size copy. Check that the registrations (side-to-side and leading edge) and image skew are correct. If they are not, adjust the registrations and image skew referring to the "Copy Adjustments" in the section of the "Replacements and Adjustments".