3001

P Sensor Setting

001*

Current

[0 to 43 / 13 / 0.1 mA ]

Allows you to reset the PWM of the ID sensor LED to avoid a service call error after clearing NVRAM or replacing the NVRAM.

The PWM data is stored by executing SP-3001-2.

002

Initialization

-

Performs the ID sensor initial setting. ID sensor output for the bare drum (VSG) is adjusted automatically to 4.0 ±0.2 V.

Press "Execute" to start. Perform this setting after replacing or cleaning the ID sensor, replacing the drum, or clearing NVRAM.

3045*

Toner End Setting DFU

001

ON/OFF

[0 to 1 / 0 / 1] 0=Off, 1=On

3902*

New PCU Detection (Not used)

001

ON/OFF Setting

[0 to 1 / 0 / 1]

0: On, 1: Off

Turns on or off the new unit detection for the transfer belt unit and fusing unit.