HOME PAGE | < Previous | Contents | Next >
Copy Adjustments: Printing/Scanning
Rev. 12/27/2012
SP No. | Specification | |
Duplex: Trailing Edge: L Size: Thick | SP2-103-10 | 0.8 mm [0.0 to 4.0 mm] |
Duplex: Trailing Edge: M Size: Thick | SP2-103-11 | 0.6 mm [0.0 to 4.0 mm] |
SP2-103-12 | 0.4 mm [0.0 to 4.0 mm] | |
Duplex: Left: Thick | SP2-103-13 | 0.1 mm [0.0 to 1.5 mm] |
Duplex: Right: Thick | SP2-103-14 |
L Size: Paper length is 297.1 mm or more.
M Size: Paper length is 216.1 to 297 mm
S Size: Paper length is 216 mm or less.
Main Scan Magnification
1. Use SP2-109-001 no 5 (Grid Pattern) to print a single dot pattern.
2. Check magnification, and then SP2-102 (Magnification Adjustment Main Scan) to adjust magnification if required. Specification: ±2%.
Parallelogram Image Adjustment
Do the following procedure if a parallelogram prints while adjusting the printing registration or printing margin using a trimming area pattern.
The following procedure should be done after adjusting the side-to-side registration for each paper tray station.
Use SP2-109-1 No. 14 (Trimming Area) to determine whether a parallelogram image appears. If the parallelogram pattern appears, perform the following procedure.
D129/D130 4-112 SM
Replacement and Adjustment
Replacement and Adjustment
Replacement and Adjustment
Rev. 12/27/2012
Copy Adjustments: Printing/Scanning
1. Laser unit [A]
2. Bracket [B] 
x2)
3. Install adjustment cam [C] (P/N: A2309003).
4. Secure positioning pin [D] (P/N A2309004) with the two screws removed with the bracket [B]. Do not tighten the screws at this time.
5. To adjust the position of the laser unit [E]
1) Adjust the laser unit position by turning the adjustment cam. (See the illustration above.)
2) Tighten the adjustment bracket.
3) Print the trimming area pattern to check the image. If the results are not satisfactory, repeat steps 5-1) to 5-3).
SM 4-113 D129/D130