HOME PAGE | < Previous | Contents | Next >
A stabilizer is attached to the machine when it is shipped. Do not remove it.
11. Turn the power switch ON.
12. Set the paper, and check that the paper size set in the paper feed tray is displayed on the operation panel.
13. Adjust the registration for the paper feed unit.
SP1-002-004 (Side-to-Side Registration Paper Tray 3)
Changing the paper size
Paper size is set as shown below when the machine is shipped from the factory. NA: LT LEF
EU.AA.CHN: A4 LEF
The paper size can be changed to A4 or LT.
1. Pull out the left tray and right tray.
2. Right tray side fence (front), [A], right tray side fence (rear) [B] and right tray end fence [C] 
×3)
LCIT PB3170
Installation
Installation
Installation
3. Attach the fences to the required position (A4 or LT).
4. Make sure that the spring [A] is attached.
5. Left tray side fence (front) [A] and left tray side fence (rear) [B] 
×2)
LCIT PB3170
6. Attach the fences to the required position (A4 or LT).
[A]: A4 position (Holes are visible) [B]: LT position (Holes are hidden)
7. Set the SP SP5-181-007 0: A4, 1: LT