HOME PAGE | < Previous | Contents | Next >

Image Transfer Unit‌‌

4.10.6 PAPER TRANSFER EXIT SENSOR

1. Open the right cover. (page 4-65 "Image Transfer Unit")

2. Fusing entrance sensor unit [A] ×1,×1)

3. Fusing entrance sensor [A]

4.10.7 TM (ID) SENSOR

Before Replacing the TM(ID) sensor

Each sensor assembly has a list of characteristic values attached to it. Before you replacing the TM / ID sensor, you must do the following procedure, or process control/MUSIC will not be done correctly after power is switched on (it will use the values for the old sensor).

 The characteristic values attached to the service part must be entered before replacement. It is recommended that in case Process control/MUSIC after replacement is not completed successfully, take a note of values of SP3-333,SP3-334,SP3-335.

1. Note the characteristic values that are listed on the bar code label.

Image Transfer Unit

 TM/P Sensor (front): F, TM/P Sensor (center): C, TM/P Sensor (rear): R, be careful.

2. Turn on the main power switch, and then go into the SP mode.

3. Input the characteristic values.

Replacement and Adjustment

Replacement and Adjustment

Replacement and Adjustment

Input data for TM/P Sensor: F into SP3-333. Input data for TM/P sensor: C into SP3-334. Input data for TM/P sensor: R into SP3-335.

HOME PAGE |

< Previous | Contents | Next >