HOME PAGE | < Previous | Contents | Next >
Booklet Finisher SR3150 / Finisher SR3140
Installation
Installation
Installation
2.17.2 INSTALLATION PROCEDURE
Only for SP3140, two stabilizers are included as accessories.
They must be attached to the finisher just after it is taken out of the shipping box.
Removal of the stabilizers must always be with the consent of the customer. Do not remove them at your own judgment.
When you install this option, turn off the power to the machine, and unplug the power plug from the wall socket.
If it is installed when the power is on, it will result in an electric shock or a malfunction.
Before installing this option, attach the “Bridge Unit BU3070” first.
Attach the “LCIT PB3170” or “Paper Feed Unit PB3160” first before installing this option.
1. Remove the external orange tape and shipping retainers.
Booklet Finisher SR3150 / Finisher SR3140
2. Open the front cover [A], and remove the filament tape and packing materials.
3. Pull out the saddle stitch unit [A] or stapling unit, and remove the filament tape and packing materials.
Booklet Finisher SR3150 / Finisher SR3140
Installation
Installation
Installation
4. Remove the items in the package (fixing screws, etc.).
5. Attach the shift tray [A] 
×1).
6. Attach the booklet tray [A] (SR3150 only).
7. Attach the extension [B] to the booklet tray, and attach the booklet tray [A] ( 
×1) (SR3150 only).
Booklet Finisher SR3150 / Finisher SR3140
8. Attach the relay guide plate [A] 
×2).
9. Attach the ground plate bracket [A] 
×2).
10. Attach the connecting brackets [A], [B] to the machine 
×4).
At this time, tighten the bracket [B] and bracket [C] of the bridge unit together.
Booklet Finisher SR3150 / Finisher SR3140
Installation
Installation
Installation
11. Connect the finisher to the machine with the connection lever [A] 
×1).
12. Attach the arm of the anti-tip component [A] 
×1). (Finisher SR3140 only)
13. Connect the interface cable to the machine.
Booklet Finisher SR3150 / Finisher SR3140
14. Turn the power switch on.
15. Check that the finisher can be selected on the operation panel, and check the finisher’s operation.