HOME PAGE | < Previous | Contents | Next >
Paper Feed Unit PB3150 (D694)
2.6 PAPER FEED UNIT PB3150 (D694)
2.6.1 ACCESSORY CHECK
No. | Descriptions | Q’ty | Remarks |
1 | Securing Bracket | 2 | |
2 | Screws - M4 × 10 | 2 | |
3 | Screw with Spring Washer - M4 × 10 | 1 |
2.6.2 INSTALLATION PROCEDURE
The main machine weighs approximately 100 kg. Make sure to lift it with the help of at least one more person.
The machine should be held at the correct locations and lifted gently by two people. If it is lifted without care, handled carelessly or dropped, it may result in injury.
When installing this option, turn OFF the main power and unplug the power cord from the wall socket. If installing without turning OFF the main power, an electric shock or a malfunction may occur.
Be sure to join the machine to the paper feed unit so as to prevent equipment from falling over. If they are not connected, they may move and fall over, resulting in injury.
Paper Feed Unit PB3150 is not supplied with a caster. You can attach the optional page 2-76 "Caster Table Type M3 (D178)".
Paper Feed Unit PB3150 (D694)
Installation
Installation
Installation
1. Remove the orange tapes and retainers.
2. Remove the accessories (fixing screws, etc.) (provided with the machine) from the package.
3. Holding the grips on the machine, align the machine with the locating pins [A], and place the machine on the paper feed unit.
When you lift the machine, hold the correct locations.
Do not hold any other parts of the machine when lifting it, because this may cause the machine to deform.
Paper Feed Unit PB3150 (D694)
Do not put the machine down on the paper feed unit as a temporary resting place. This may cause the paper feed unit to deform. Always connect the machine and paper feed unit properly.
4. Pull out the 2nd paper feed tray.
5. Using a securing bracket as a screwdriver, fix the machine to the feed unit (spring washer: screw: M4×10: 1).
6. Attach the securing brackets [A] to two positions on the left and right at the rear of the machine (screws: 1 each).
Paper Feed Unit PB3150 (D694)
Installation
Installation
Installation
7. Reattach the paper feed tray to the machine.
8. Attach the decals as shown below.
[A]: Tray number decal [B]: Paper size decal
The tray number decal and paper size decal are packaged together with the machine.
9. Connect the power cord to the machine.
10. Turn ON the main power.
11. Set the paper, and check that the paper size set in the paper feed tray is displayed on the operation panel.
12. Adjust the registration for the paper feed unit.
SP1-002-004 (Side-to-Side Registration Paper Tray 3)
SP descriptions
SP1-002 (Side-to-Side Registration)
Adjusts the side-to-side registration by changing the laser main scan start position for each mode and tray.
Increasing a value: The image is moved towards the rear edge of the paper. Decreasing a value: The image is moved towards the front edge of the paper.