HOME PAGE | < Previous | Contents | Next >
Troubleshooting for Finishing Options
9. Re-attach the left lower cover 
x2)
10. Re-attach the finisher front cover 
x2)
6.16.4 PAPER CURL PROBLEM FOR SR3180 (D766)
When using the mixed mode, duplex (curls towards the lower side) over the simplex (curl towards the upper side) and paper curl occurs, attach the auxiliary tray (D7667010), disable the paper exit full sensor, and paste the Mylar.
1. Remove the paper exit cover [A] 
×2)
2. Release the clamp and disconnect the harness of the paper exit full sensor 1 [A].
3. Loop and clamp the harness [A] as shown.
4. Release the clamp and disconnect the harness of the paper exit full sensor 2 (Staple) [A].
Troubleshooting
Troubleshooting
Troubleshooting
Troubleshooting for Finishing Options
5. Loop and clamp the harness [A] as shown.
If the harness cable [A] is short to loop, clamp the harness without looping.
6. Re-attach the paper exit cover ( ×2)
7. Attach the auxiliary tray (D7667010) [B] to the paper exit tray [A]
8. Paste the Mylars [A] on the frame of the finisher.