HOME PAGE | < Previous | Contents | Next >
Troubleshooting for Transport/Paper Feeding of the Machine
Troubleshooting
Troubleshooting
Troubleshooting
Waste toner bottle is never full
Target Part/SP No.: Waste Toner Bottle Full Sensor / SP5-803-032 (Toner Collection Full Sensor)
Cause verification | Problem Judgement |
Execute an INPUT check with feeler within the sensor detection range (Done after removing the waste toner bottle) | 0: Not full |
Solution:
Clean the sensor.
Reconnect the connector.
Replace the sensor.
Replace the Imaging IOB.
Replace the harness.
No waste toner bottle set is displayed on controller board even when it is clear that is set
Target Part/SP No.:Waste Toner Bottle Set Sensor / SP5-803-033 (Toner Collection Bottle Set Sensor)
Cause verification | Problem Judgement |
Execute an INPUT check with the feeler within the sensor detection range (Done after removing the waste toner bottle) | 1: Not set |
Solution:
Reconnect the connector.
Replace the sensor.
Replace the Imaging IOB.
Replace the harness.
Waste toner bottle is not detected even when it is set
Target Part/SP No.:Waste Toner Bottle Set Sensor / SP5-803-033 (Toner Collection Bottle Set Sensor)
Cause verification | Problem Judgement |
Detach the waste toner bottle from the machine. | 0: Set |