HOME PAGE | < Previous | Contents | Next >
Troubleshooting for Transport/Paper Feeding of the Machine
Cause verification | Problem Judgement |
Manually press the referenced switch (Done after opening the duplex guide plate) | 1: Open |
Open the duplex guide plate. | 0: Close |
Solution:
Reconnect the connector.
Replace the sensor.
Replace the Paper Transport IOB.
Replace the harness.
Replace the 2nd paper feed tray.
Replace the 2nd paper feed tray.
Replace the 2nd paper feed tray.
Pick-up Arm
Check the switch for the pick-up arm to see if there are any defects.
Check the switch for the pick-up arm to see if there are any defects.
Check the switch for the pick-up arm to see if there are any defects.
6.15.5 OTHERS
If the error occurs periodically, do the following steps. If the result is as shown in the "Problem Judgement" column, follow the solutions.
"Replace the waste toner bottle" is displayed even when it is clear that the waste toner bottle is not full
Target Part/SP No.: Waste Toner Bottle Full Sensor / SP5-803-032 (Toner Collection Full Sensor)
Cause verification | Problem Judgement |
Execute an INPUT check with no feeler in the sensor detection range (Done after detaching the waste toner bottle) | 1: Full |
Solution:
Clean the sensor.
Reconnect the connector.
Replace the sensor.
Replace the Imaging IOB.
Replace the harness.