HOME PAGE | < Previous | Contents | Next >
Troubleshooting for Transport/Paper Feeding of the Machine
6.15.4 DISPLAY ERROR
"No paper in Tray 1" is displayed even when the paper is in
Target Part/SP No.:Paper End Sensor (1st Feed Tray) / SP5-803-015 (Tray 1: Paper End Detection)
Cause verification | Problem Judgement |
Execute an INPUT check when there is no paper at the position of the referenced sensor. | 1: Paper detected |
Execute an INPUT check when there is paper at the position of the referenced sensor. | 0: Paper not detected |
Solution:
Reconnect the connector.
Replace the sensor.
Replace the Paper Transport IOB.
Replace the harness.
Feeler for 1st paper end sensor
Cause verification | Problem Judgement |
Check if the feeler for 1st paper end sensor is unfastened. | Feeler is unfastened. |
Solution:
Reinstall the feeler.
Check if there are any defects in the 1st paper feed unit.
"No paper in Tray 2" is displayed even when the paper is in
Target Part/SP No.:Paper End Sensor (2nd Feed Tray) / SP5-803-019 (Tray 2: Paper End Detection)
Cause verification | Problem Judgement |
Execute an INPUT check when there is no paper at the position of the referenced sensor. | 1: Paper detected |