HOME PAGE | < Previous | Contents | Next >
Troubleshooting for Transport/Paper Feeding of the Machine
Duplex Entrance Sensor: Lag Jam: Cause Code 067
Target Part/SP No.:Duplex Entrance Sensor / SP5-803-011
Cause verification | Problem Judgement |
Execute an INPUT check when there is no paper at the position of the referenced sensor. | 0 :Paper detected |
Execute an INPUT check when there is paper at the position of the referenced sensor. | 1: Paper not detected |
Solution:
Clean the sensor.
Reconnect the connector.
Replace the sensor.
Replace the Paper Transport IOB.
Replace the harness.
Target Part/SP No.:Duplex Entrance Motor/ SP5-804-065 (Duplex Entrance Motor:CW:Standard Speed)
Cause verification | Problem Judgement |
Turn the referenced motor OFF with OUTPUT check | Drive sound heard |
Turn the referenced motor ON with OUTPUT check | Drive sound not heard |
Solution:
Reconnect the connector.
Replace the sensor.
Replace the Paper Transport IOB.
Replace the harness.
Target Part/SP No.:Duplex/ Bypass Motor / SP5-804-071 (Duplex Bypass Motor:CW:Standard Speed)
Troubleshooting for Transport/Paper Feeding of the Machine
Cause verification | Problem Judgement |
Turn the referenced motor OFF with OUTPUT check | Drive sound heard |
Turn the referenced motor ON with OUTPUT check | Drive sound not heard |
Troubleshooting
Troubleshooting
Troubleshooting
Solution:
Reconnect the connector.
Replace the sensor.
Replace the Paper Transport IOB.
Replace the harness.
Checking paper jam, or paper status
Check if there is no double feeding. | Fan the paper. |
Check if the paper is curled too much. | If the paper is curled too much, switch on the anti-condensation heater for paper tray. |
Check if extra thin paper or thick paper exceeding the supported paper thickness is being used. | Use a supported paper type. |
Check if the paper thickness and size are detected correctly. | Set the paper thickness and size to the correct value. |