HOME PAGE | < Previous | Contents | Next >
Installation
Installation
Installation
Checking the Copy Image with the Test Chart
Make a copy of a test chart and check the output quality.
Paper Settings
Adjusts the side-to-side registration, refer to the “Image Adjustment” > “Registration” section.
1. Enter SP2-109-003.
2. Print out the test pattern (14: Trimmed area) with SP2-109-003.
3. If necessary, adjust the registration for the paper feed tray.
SP1-002-001 (Side-to-Side Registration: By-pass Tray)
SP1-002-002 (Side-to-Side Registration: Paper Tray 1)
SP1-002-003 (Side-to-Side Registration: Paper Tray 2)
SP1-002-006 (Side-to-Side Registration: Duplex)
If optional paper trays is installed, do the following SPs as well:
SP1-002-004 (Side-to-Side Registration: Paper Tray 3)
SP1-002-005 (Side-to-Side Registration: Paper Tray 4)
4. If necessary, adjust the registration for ADF.
SP6-006-001 (ADF Adjustment: Side-to-Side Regist: Front)
SP6-006-002 (ADF Adjustment: Side-to-Side Regist: Rear)
5. If necessary, adjust the registration for Scanner.
SP4-803-001 (Home Position Adj Value)
SP4-011-001 (Main Scan Reg)
SP descriptions
SP1-002 (Side-to-Side Registration)
Adjusts the side-to-side registration by changing the laser main scan start position for each mode and tray.
Increasing a value: The image is moved towards the rear edge of the paper. Decreasing a value: The image is moved towards the front edge of the paper.
SP2-109-003 (Test Pattern: Pattern Selection)
Selects the test pattern.