HOME PAGE | < Previous | Contents | Next >
Item | Description |
Paper Type | N: Normal paper MTH: Middle thick paper TH: Thick paper |
Paper Feed Station | P: Paper tray B: Bypass tray |
Print Mode | S: Simplex D: Duplex |
Others
The settings of each SP mode are explained in the right-hand column of the SP table in the following way.
[Adjustable range / Default setting / Step] Alphanumeric
If "Alphanumeric" is written to the right of the bracket as shown above, the setting of the SP mode shows on the screen using alphanumeric characters instead of only numbers. However, the settings in the bracket in the SP mode table are explained by using only the numbers.
The following symbols are used in the SP mode tables.
Notation | What it means |
ENG | Engine SP |
CTL | Controller SP |
FA | Factory setting: Data may be adjusted from the default setting at the factory. Refer to the factory setting sheets enclosed. You can find it in the front cover. |
DFU | Design/Factory Use only: Do not touch these SP modes in the field. |
* | An asterisk (*) to the left side of ENG/CTL column means that this mode is stored in the NVRAM. If you do a RAM clear, this SP mode will be reset to the default value. "ENG" and "CTL" show which NVRAM contains the data. *ENG: NVRAM on the BCU board *CTL: NVRAM on the controller board |
System Maintenance
System Maintenance
System Maintenance
Service Program Mode
Notation | What it means |
SSP | This denotes a "Special Service Program" mode setting. |