HOME PAGE | < Previous | Contents | Next >
Replacement and Adjustment
Replacement and Adjustment
Replacement and Adjustment
4.11.5 PAPER TRANSFER ROLLER UNIT
What to Do before Replacing the Paper Transfer Roller Unit
Before replacing the Image Paper Transfer Roller Unit, set SP3-701-109 to "1" and switch the power OFF. Then replace the Image Paper Transfer Roller Unit and switch the power ON. SP3-701 (Manual New Unit Set)
This SP is the new unit detection flag.
0: new unit detection flag OFF, 1: new unit detection flag ON
Item | SP |
Paper Transfer Roller Unit | SP3-701-109 |
Replacement
1. Open the right door.
2. Remove the right clip ring and connector on the rear side.
3. Pull the handle [A] and open the paper transfer unit [B].
Image Transfer Unit
4. Remove the left clip ring at the front side, and remove the paper transfer roller unit [A].
Note that the sizes of the clip ring differ on the left and right.
When attaching a paper transfer roller unit, first attach the bushings [A] to the paper transfer roller unit.
Replacement and Adjustment
Replacement and Adjustment
Replacement and Adjustment