HOME PAGE | < Previous | Contents | Next >
4.6 ADF
4.6.1 ADF REMOVAL
1. Rear cover (page 4-14)
2. Cable bracket and connector SPDF DF3100
ARDF DF3090
ADF
Replacement and Adjustment
Replacement and Adjustment
Replacement and Adjustment
3. Screws on the ADF base. SPDF DF3100
ARDF DF3090
4. Slowly and carefully (the ADF is heavy) lift the ADF [A] off the machine.
5. Set the ADF on its edge on the floor, and then lean it against a wall [B].
ADF
To prevent damage to the fragile feelers [A] of the ADF position sensor, never lay the ADF on a flat surface as shown below.
If the SPDF DF3100 is being replaced, do SP4-730-002 after the new SPDF has been installed.
SP descriptions
SP4-730-002 (FROM Main Factory Setting Execution ON/OFF)
Copies the parameters written in FROM in the SPDF to the engine board in the MFP. This SP is only for the SPDF models.