HOME PAGE | < Previous | Contents | Next >
Internal Finisher SR3130 (D690)
[A]: Front parallel, one position [B]: Back parallel, one position [C]: Parallel, two position
Paper eject (bundle eject)
After stapling, the eject paper open/close guide plate descends, and ejects the bundle of paper while gripping it with the eject roller.
Paper press mechanism
For ejected paper, a paper press unit is provided to immobilize the paper above the tray. It is driven by a paper press drive motor (motor operates CW/CCW)
The paper press unit is provided with a paper surface sensor which detects the upper part of the paper, and a Home Position sensor which detects the home position of the paper press unit. The paper surface sensor detects the number of sheets in the tray, and if the number is large, it descends the tray to a suitable position.
Tray drive mechanism
The eject tray has a mechanism which descends the tray to a suitable position. This is driven by a tray drive motor (motor operates CW/CCW). It operates when the paper surface sensor cannot detect paper in the tray, and descends the eject tray until detection is performed.
Tray full detection mechanism
When the eject tray descends to its maximum, a full detect sensor below is covered by the eject tray filler, and it is detected that the top of the tray is full. During full tray detection, paper transport is temporarily stopped. After the paper bundle is released, the tray is raised to a suitable position, and the eject operation is repeated.
INTERNAL FINISHER SR3130 (D690)
INTERNAL FINISHER SR3130 (D690)
INTERNAL FINISHER SR3130 (D690)
Internal Finisher SR3130 (D690)
No. | Description | No. | Description |
1 | Paper exit tray | 5 | Stack height lever HP sensor |
2 | Stack height detection lever | 6 | Full sensor |
3 | Stack height lever motor | 7 | Tray lift motor |
4 | Paper surface sensor |