HOME PAGE | < Previous | Contents | Next >
Internal Finisher SR3180 (D766)
Installation
Installation
Installation
2.19.3 STAPLELESS STAPLER INITIAL SETTINGS
To adjust the strength of the crimp between sheets of stapled paper, there is a setting to select either single or double stapling.
The crimp is weakened when there is an image (toner) at the point which is to be stapled. There also is a setting to mask the image on the point for stapling, in order to prevent the crimp from being weakened.
Depending on users demands, explain the settings/methods of the settings by checking the following instructions.
How to Change the Setting of Staple Method for Stapleless Stapler
Use this procedure to select the type of stapling that is done by the stapleless stapler.
Note that if you change the finisher type from Finisher SR3210 to Internal Finisher SR3180, which has the same type of stapleless staple unit, the current setting in [Stapling Method for Stapleless Stapler] is not carried over, so configure the setting again.
1. Press the [User Tools] icon on Home screen.
2. Press [Machine Features] > [System Setting] > [General Setting] >[Stapling Method for Stapleless Stapler].
3. Select [Double] or [Single].
