HOME PAGE | < Previous | Contents | Next >
Installation
Installation
Installation
2.18.2 INSTALLATION PROCEDURE
When installing this option, turn OFF the main power and unplug the power cord from the wall socket. If installing without turning OFF the main power, an electric shock or a malfunction may occur.
When supplied together with the "Internal Finisher SR3130", attach this option before installing the "Internal Finisher SR3130"
If the "Internal Finisher SR3130" is already attached, attach this option after removing the finisher.
1. Take out from the box, and remove the filament tape and packing material.
2. Remove the finisher and finisher front right cover from the machine.
3. Perform steps 1 to 21 of the installation procedure for the "Internal finisher SR3130".page 2-144 "Internal Finisher SR3130 (D690)"
4. Change the fixing position of the bracket [A] of the bottom plate 
×1).
5. Replace the lock holder of the bottom plate with the lock holder [A] 
×1) provided with the accessories.
Punch Unit PU3040 (D716)
6. Reattach the front upper cover.
7. Pass the shafts [B] of the punch unit [A] through the bearings [C] of the bottom plate, and attach to the machine 
×1, knob screw).
If it is difficult to insert by probing, look from the side while you insert it into the bearings of the bottom plate.
8. When installing the punch unit in a finisher that is already installed, remove the relay guide plate [A] 
×2).
Installation
Installation
Installation
Punch Unit PU3040 (D716)
This step is unnecessary when installing the finisher and punch unit at the same time.
9. Attach the punch unit cover [A] provided with the accessories, inserting the tabs 
×1).
10. Insert the hopper [A].
Punch Unit PU3040 (D716)
11. Slide the finisher [A] along the rail of the bottom plate from the left-hand side of the machine to attach it 
×1).
12. Attach the components [A] and [B] to the finisher 
×2).
13. Attach the left rear cover.
14. Insert the upper left cover [A] from the front, and slide it to attach it.
Installation
Installation
Installation
Punch Unit PU3040 (D716)
15. Attach stabilizers.
Because the weight is biased to the right of the machine if the internal finisher is installed, stabilizers are required on the left side. Because they are included with the finisher, install these stabilizers at the same time as you install the internal finisher.
16. Remove the connector cover, then connect the interface cable to the machine.
17. Move the stapler unit forward, then set the stapler [A].
Punch Unit PU3040 (D716)
18. Turn ON the main power.
19. Check that the finisher can be selected at the operation panel, and check the finisher and punch operation.