HOME PAGE | < Previous | Contents | Next >
Installation
Installation
Installation
2.13.2 INSTALLATION PROCEDURE
When installing this option, turn OFF the main power and unplug the power cord from the wall socket. If installing without turning OFF the main power, an electric shock or a malfunction may occur.
The side tray cannot be used together with the following peripherals:
- Internal Shift Tray SH3070 (D691)
- Bridge Unit BU3070 (D685)
- Internal Finisher SR 3180 (D766)
- Internal Finisher SR 3130 (D690)
To use together with the "1 Bin Tray BN3110 (D3CQ)", attach the "1 Bin Tray BN3110 (D3CQ)" first before installing the side tray.
1. Remove the orange tapes, shipping retainers, and accessories (fixing screws, etc.).
2. Remove the paper exit tray [A].
Side Tray Type M3 (D725)
3. Remove the paper exit feeler [A].
4. Remove the driven roller [B] at the machine’s exit tray and attach the supplied driven roller [A].
Insert a flathead screwdriver into the depression in the center, and then, lifting the driven roller, unlock the part indicated by the red arrow.
When attaching the driven roller, push its center all the way in until it clicks.
[A]: The supplied driven roller has flat rollers.
[B]: The machine’s standard driven roller has drum-type rollers (as indicated by red frames).
Side Tray Type M3 (D725)
Installation
Installation
Installation
5. Attach the paper support guide [A] (Tab x4 ).
6. Open the right door, and then remove the small cover [A].
7. Remove the screw and connector, and then remove the front upper cover [A].
Remember that there are three tabs at the positions of the red arrows.
Tilt the operation panel [B] upward to a horizontal position, and then remove the front upper cover [A].
Side Tray Type M3 (D725)
8. Attach the bracket [A].
9. Remove the connector cover [A].
10. Attach the bracket [A].
Side Tray Type M3 (D725)
Installation
Installation
Installation
11. Reattach the front upper cover, and close the right door.
12. Attach the side tray unit [A] to the machine, and fix with a knob screw.
13. Attach the fixing plate [A] 
×1).
14. Attach the upper extension tray [A] and the left extension tray [B].
15. Turn ON the main power.
16. Check that paper output to the side tray can be selected at the operation panel, and check the operation.