For installing the tray heater in the D581 (LCT)

10. Reassemble the mainframe and optional paper feed unit.

1. Remove the rear cover of the mainframe x 6).

2. Pull out the LCT drawer.

Installation

 If the right tray comes out with the left tray, push the right tray into the LCT.

3. Left tray [1] x 2)

4. Remove the right tray [2] while pressing down the stopper [3].

 When reinstalling the right tray, set the right tray on the guide rail and carefully push the tray in, making sure to keep the tray level.

Tray Heater (Optional Paper Feed Unit)

5. Install the tray heater [4] in the optional LCT x 1).

6. Remove the two securing brackets [5] x 1 each), and then the rear cover [6] of the optional LCT x 2).

7. Connect the harness [7] to the connector [8] of the tray heater.

8. Route the harness [7] as shown and clamp it with four clamps x 4).

Tray Heater (Optional Paper Feed Unit)

9. Connect the harness [7] to the connector [9] of the mainframe.

10. Reassemble the rear cover of the optional LCT.

Installation

11.

12. Release the optional heater relay connector [11] x 1).

13. Connect the optional heater relay connector to the connector [12] (rear side) of the main frame x 1).

14. Reassemble the mainframe and optional LCT.