HOME PAGE | < Previous | Contents | Next >
Bridge Unit Installation (D634)
2.9.2 INSTALLATION PROCEDURE
Unplug the copier power cord before starting the following procedure.
Installation
Installation
Installation
If you will install the 1-bin tray (D632) on the machine, install the 1-bin tray first before installing the bridge unit (D634). This makes it easy to do the following procedure.
If you will install the finisher unit (D588, D636 or D637) on the machine, install it after installing the bridge unit (D634).
1. Remove all tapes.
2. If the sensor feeler [A] is out, fold it into the machine.
3. Open the right door of the machine.
4. Remove the upper inner tray [A].
5. Remove the front right cover [B] 
x 1).
6. Remove the connector cover [C] 
x 1).
Bridge Unit Installation (D634)
7. Attach the two guides [A] to the cutouts [B] in the inner tray.
1) Place the lower hook of the guide in the cutout of the paper exit.
2) Attach the guide as shown until the two side hooks hold the paper exit.
3) Press the guide.
4) Press down the guide as shown.
Bridge Unit Installation (D634)
Installation
Installation
Installation
8. Install the bridge unit [A] in the machine.
9. Secure the bridge unit with the long knob screw [A] and knob screw [B].
10. Attach the frame cover [C].
11. Reinstall the front right cover on the machine, and then close the right door of the machine.
Open the bridge unit cover [D] when installing the front right cover. Otherwise, you cannot reinstall it.
12. Install the optional finisher (refer to the finisher installation procedure).
Bridge Unit Installation (D634)
Holder bracket [E] is used in the installation procedure of the finisher (D588, D636 or D637). Do not install it at this time.
13. Pull out the extension tray [A] only if the 1000-sheet finisher (D588) will be installed on the main machine.
14. Turn on the main power switch of the machine.
15. Check the bridge unit operation.