HOME PAGE | < Previous | Contents | Next >
1-Bin Tray Unit Installation (D632)
2.8.2 INSTALLATION PROCEDURE
Unplug the copier power cord before starting the following procedure.
If the bridge unit (D634) or side tray (D635) has already been installed in the machine, remove it before installing 1-bin tray unit (D632). This will make it easier for you to do the following procedure.
1. Remove all tapes.
2. Open the right door of the machine.
3. Remove the front right cover 
p.4-6).
4. Remove the paper exit cover 
p.4-8).
Keep the screw removed in step 4 for step 5.
5. Install the 1 bin tray unit [A] ( x 1, x 1 [This screw was removed in step 4]).
6. Attach the tray support bar [A] to the tray [B] as shown, and then attach the end-fence [C].
1-Bin Tray Unit Installation (D632)
Installation
Installation
Installation
7. Install the tray [A] with the tray support bar in the machine (M3 x 16: 
x 2).
8. Connect the harness to the connector of the 1-bin tray unit 
x 1).
9. Attach the harness cover [A] ( x 1; M3 x 8).
10. Reinstall the front right cover on the machine, and then close the right door of the machine.
11. Turn on the main power switch of the machine.
12. Check the 1-bin tray unit operation.