101

D

Exposure lamp error

-001: Shading at AGC

-002: Shading at scanning

 The standard white level was not detected properly when scanning the white plate

 Exposure lamp defective

 Lamp stabilizer defective

 Exposure lamp connector defective

 Standard white plate dirty

 Scanner mirror or scanner lens out of position or dirty

 SBU defective

 BCU defective

The peak white level is less than 64/255 digits (8 bits) when scanning the shading plate. (The shading data peak does not reach the specified threshold)

120

D

Scanner home position error 1

The scanner home position sensor does not detect the "OFF" condition during initialization or copying.

 SIB (B/W), SIB (Color) or scanner drive motor defective

 Scanner motor defective

 Harness between SIB and scanner drive motor disconnected

 Harness between SIB and scanner drive motor power source disconnected

 Scanner HP sensor defective

 Harness between SIB and HP sensor disconnected

 Scanner wire, timing belt, pulley, or carriage defective

 BCU defective

121

D

Scanner home position error 2

The scanner home position sensor does not detect the "ON" condition during initialization or copying.

 SIB (B/W), SIB (Color) or scanner motor drive board defective

 Scanner motor defective

 Harness between SIB and scanner drive motor disconnected

 Harness between SIB and scanner drive motor power source disconnected

 Scanner HP sensor defective

 Harness between SIB and scanner HP sensor disconnected

 Scanner wire, timing belt, pulley, or carriage defective

 BCU defective

141

D

Black level detection error

The black level cannot be adjusted within the target value during the zero clamp.

 Defective SBU

 BCU defective

142

D

White level detection error

The white level cannot be adjusted within the target during auto gain control.

 Dirty exposure glass or optics section

 SBU board defective

 Exposure lamp defective

 Lamp stabilizer defective

 BCU defective

144

D

SBU connection error

The SBU connection cannot be detected at power on or recovery from the energy save mode.

 Defective SBU

 Defective harness

 Defective detection port on the BCU

161

D

IPU error

The error result of self-diagnostic by the ASIC on the IPU is detected.

 Defective IPU

 Defective connection between IPU and SBU

162

D

IPU PCIE Communication error

The link up interrupt did not proceed from the LYRA when the main switch was turned on or when recovering from the energy saver mode.

 Defective IPU

 Defective BCU

165

D

Copy Data Security Unit error

The copy data security board is not detected when the copy data security function is set "ON" with the initial setting.

A device check error occurs when the copy data security function is set to "ON" with the initial setting.

 Incorrect installation of the copy data security board

 Defective copy data security board