HOME PAGE | < Previous | Contents | Next >
5.12.2 UPDATING FIRMWARE
Preparation
1. If the SD card is blank, copy the entire "romdata" folder onto the SD card.
2. If the card already contains the "romdata" folder, copy the "D129" folder onto the card.
Updating Procedure
Service Tables
Service Tables
Service Tables
1. Turn the main power switch off.
2.
3. Insert the SD card into SD Card Slot 2 (Lower Slot) [A]. Make sure the label on the SD card faces the rear side of the machine.
4. Slowly push the SD card into the slot so it locks in place. You will hear it click. Make sure the SD card locks in place.
Updating the Firmware
To remove the SD, push it in to unlock the spring lock. Then release it so it pops out of the slot.
5. Disconnect the network cable from the copier if the machine is connected to a network.
6. Switch the main power switch on. After about 45 seconds, the initial version update screen appears on the LCD in English.
7. On the screen, touch the button or press the corresponding number key on the operation panel to select the item in the menu that you want to update.
ROM/NEW | What it means |
ROM: | Tells you the number of the module and name of the version currently installed. The first line is the module number, the second line the version name. |
NEW: | Tells you the number of the module and name version on the SD card. The first line is the module number, the second line the version name. |
Controller, engine and operation panel firmware cannot be updated at the same time. It is recommended to update firmware modules one by one.
8. Touch "UpDate (#)" (or 
) to start the update.
While downloading is in progress, the LCD will display "Loading". When downloading has been completed, the panel will display "update done".
For operation panel software, the Start key lights red while downloading is in progress, and then lights green again after downloading is completed.
9. The "Update is Done" message appears on the operation panel after completing the updating. The message differs depending on the firmware that has been updated.
10. Switch the copier main power switch off when you see the "Update is Done" message or follow the procedure that is displayed on the operation panel.
11. Press in the SD card to release it. Then remove it from the slot.
12. Switch the copier on for normal operation.