HOME PAGE | < Previous | Contents | Next >
3. After machine servicing is completed:
Change SP5169 from "1" to "0".
Turn the machine off and on.
Tell the administrator that you completed servicing the machine.
The administrator will then set the "Service Mode Lock" to ON.
5.1.2 SERVICE PROGRAM MODE TABLES
Please note these general changes in this section:
Group 8(Data Log 2) is a new group of counters.
Along with the addition of Group 8, many of the Group 7 counters have been removed.
Service Table Key
Notation | What it means |
[range / default / step] | Example: [-9 to +9 / 0 / 0.1 mm step]. The setting can be adjusted in the range ±9, value reset to +3.0 after an NVRAM reset, and the value can be changed in 0.1 mm steps with each key press. |
* | Value stored in NVRAM. After a RAM reset, this default value (factory setting) is restored. |
DFU | Denotes "Design or Factory Use". Do not change this value. |
Japan only | The feature or item is for Japan only. Do not change this value. |
C2b | D129 |
C2c | D130 |
SSP | This denotes a "Special Service Program" mode. |