x 1)HOME PAGE | < Previous | Contents | Next >
5. Bracket [D] x 1)
6. Pull the drum [E] towards the front 
(the left side in the illustration) while releasing the charge roller [F] using the release levers 
[G], and then remove the drum 
.
Replacement and Adjustment
Replacement and Adjustment
Replacement and Adjustment
Never touch the drum surface with bare hands.
Re-installation
1. Replace the drum and close the PCDU 
x 2).
2. Put the opening cap [A in the previous procedure] back in its original place.
3. After replacing the drum, do these SPs:
SP 2001: Charge Bias Setting – make sure that this is at the default setting
SP 3001-2: P Sensor Initial Setting (P sensor = ID Sensor)
SP 2805: Process Setting
SP 2810-1: Grayscale Setting