HOME PAGE | < Previous | Contents | Next >
2.4 PAPER FEED UNIT PB3150
2.4.1 ACCESSORY CHECK
Description | Q’ty |
Securing Bracket | 2 |
Screw with Spring Washer - M4 × 10 | 1 |
Screws - M4 × 10 | 2 |
Rating label | 1 |
Decal - EMC Address | 1 |
2.4.2 INSTALLATION PROCEDURE
The machine should be held at the correct locations and lifted gently by two people.
If it is lifted without care, handled carelessly or dropped, it may result in injury.
When installing this option, turn the machine power OFF, and unplug the power supply cord from the wall socket.
If it is installed with the power on, it may result in an electric shock or a malfunction.
Be sure to join the machine to the paper feed unit so as to prevent equipment from falling over.
If they are not connected, they may move and fall over, resulting in injury.
1. Remove the orange tape and retainers.
2. Remove the items provided (fixing screws, etc.) from the package.
3. Holding the grips on the machine, align it with the locating pin [A], and place the machine on the paper feed unit.
Paper Feed Unit PB3150
Installation
Installation
Installation
When you lift the machine, hold the correct locations.
In particular, do not lift the machine by holding the scanner unit, etc., because this may cause the machine to deform.
Do not put the machine down on the paper feed unit as a temporary resting place. This may cause the paper feed unit to deform. Always connect the machine and paper feed unit properly.
4. Pull out the 2nd paper feed tray.
5. Using a securing bracket as a screwdriver, fix the machine to the feed unit (spring washer: screw: M4×10: 1).
6. Attach the securing brackets [A] to two positions on the left and right at the rear of the machine (screws: 1 each).
Paper Feed Unit PB3150
7. Return the paper feed tray to the machine.
8. Attach the decals as shown below.
[A]: Tray number decal [B]: Paper size decal
The tray number decal and paper size decal are packaged together with the machine.
9. Connect the power cord to the machine.
10. Turn the power switch ON.
11. Set the paper, and check that the paper size set in the paper feed tray is displayed on the operation panel.
12. Adjust the registration for the paper feed unit.
SP1-002-004 (Side-to-Side Registration Paper Tray 3)