HOME PAGE | < Previous | Contents | Next >
2.2.5 MOVING THE MACHINE
This section shows you how to manually move the machine from one floor to another floor. See the section "Transporting the Machine" if you have to pack the machine and move it a longer distance.
Installation
Installation
Installation
Before turning off the main power, make sure 100% is shown as available memory on the screen if the fax option is installed.
Turn off the main power.
Disconnect the power plug from the outlet.
Close all covers and paper trays, including the front cover and bypass tray.
Keep the machine level and carry it carefully, taking care not to jolt or tip it, and protect the machine from strong shocks.
When moving the machine, do not press against the ADF.
2.2.6 TRANSPORTING THE MACHINE
Main Frame
1. Remove the toner cartridges. This prevents toner flow into the toner supply tube, which is caused by vibration during transport. This can also cause the tube to be clogged with toner.
2. Make sure there is no paper left in the paper trays. Then fix down the bottom plates with a sheet of paper and tape.
3. Take out the scanner stay from inside the front door and install the scanner stay.
4. Do one of the following:
Attach shipping tape to the covers and doors.
Shrink-wrap the machine tightly.
After you move the machine, make sure you do the "Auto Color Registration" as follows. This optimizes color registration.
1. Do the "Forced Line Position Adj. Mode d" (SP2-111-4).
2. The result can be checked with SP2-194-007 (MUSIC Execution Result Execution Result) (0:Succeed, 1:Fail).
Also, results for each color can be checked with SP2-194-010 to 013.
Make sure that the side fences in the trays are correctly positioned to prevent color registration errors.