HOME PAGE | < Previous | Contents | Next >
7.1 TO UPDATE EXJS
1. Put the SD card containing the firmware to install in SD card slot 2 [A], and switch on the power.
D148/D149/D150:
D146/D147:
Updating the EXJS
Updating the EXJS
Updating the EXJS
2. Wait until the update screen starts.
3. When the update screen is displayed, select [browser], and press the [Update (#)] button.
4. When "Update done." is displayed, switch the power OFF, and remove the SD card from SD card slot 2.
<When updating Extension JavaScript, add the following steps>
5. Switch the power ON.
6. Press the [Default setting/counter] key.
7. Press the [Extension function default setting] button.
To Update EXJS
8. Press the [Extension function default setting] button on the [Extension function default menu setting] screen.
9. Stop "Extended JS" on the “Startup setting” condition with a tab.
10. Switch the power OFF.
11. Insert the Extended JavaScript upgrade SD card in SD card slot 2.
12. Switch the power ON.
13. Press the [Default setting/counter] key.
14. Press the [Extension function default setting] button.
15. Press the [Extension function default setting] button on the [Extension function default menu setting] screen.
16. Press the [Install] tab.
17. Press [SD card], and select "Extended JS" from the list of extension functions.
18. Select [MFP hard disk] as the installation location, and press [Next].
19. After checking extension function information on the “Installation preparation complete” screen, press the [Enter] button.
20. "The following extension functions are already installed. The message “Overwrite extension function?” is displayed. Press the [Continue] button.
21. When installation is complete, the message “Extension function has been installed" is displayed. Press the [OK] button.
22. On the [Startup settings] tab, set [Extended JS] to the startup standby state, and switch the power OFF.
23. Remove the SD card from SD card slot 2, and return the controller cover.
24. Switch the power ON.
25. Press the [Default setting/counter] key.
26. Press the [Extension function default setting] button.
27. Press the [Extension function default setting] button on the [Extension function default menu setting] screen.
28. Check the version of [Extended JS] on the [Startup settings] tab is the latest version.
If the power is ON before starting Step 1, switch the power OFF after first performing Steps 5-9, and perform Step 1 and subsequent steps. In that case, skip Steps 5-10. (This saves time.)
If you do not plan to update Extension JavaScript, return the controller cover to the original position after performing Step 5.