HOME PAGE | < Previous | Contents | Next >
Standard: 0 ± 2mm for the leading edge registration, 0 ± 2.5mm for the side-to-side registration.
SP mode | |
Leading Edge Registration | SP4-010-001 |
Side-to-Side Registration | SP4-011-001 |
4.19.2 ARDF
ARDF side-to-side, leading edge registration and trailing edge
A: Leading edge registration
Use A3/DLT paper to make a temporary test chart as shown above.
1. Put the temporary test chart on the ARDF. Then make a copy from one of the feed stations.
2. Check the registration. Check the leading edge and side-to-side registration. Adjust the following SP modes if necessary.
Standard: 4.2 ± 2 mm for the leading edge registration, 2 ± 1 mm for the side-to-side registration. Use the following SP modes to adjust if necessary.
SP Code | What It Does | Adjustment Range |
SP6-006-001 | Side-to-Side Regist: Front | ± 3.0 mm |
SP6-006-003 | Leading Edge Registration | ± 5.0 mm |
SP6-006-005 | Buckle: Duplex Front | ± 3.0 mm |
SP6-006-006 | Buckle: Duplex Rear | ± 2.5 mm |
SP6-006-007 | Rear Edge Erase (Trailing Edge) | ± 10.0 mm |