HOME PAGE | < Previous | Contents | Next >
4.10.2 IMAGE TRANSFER CLEANING UNIT
When removing the image transfer cleaning unit, to prevent scattering of toner, remove it so that the image transfer cleaning unit is underneath the image transfer belt unit.
Adjustment before replacing the image transfer cleaning unit
Before replacing the Image Transfer Belt Cleaning, set SP3-701-093 to "1" and switch the power OFF.
Then replace the Image Transfer Belt Cleaning and switch the power ON.
Replacement
1. Image transfer unit (page 4-65 "Image Transfer Unit")
2. Image transfer lock unit [A] 
×3, Among them, stepping screw ×1)
3. Remove the screw above the image transfer cleaning unit [A] 
×2).
Image Transfer Unit
Replacement and Adjustment
Replacement and Adjustment
Replacement and Adjustment
4. Turn the whole image transfer belt unit over, and remove the screw below the image transfer cleaning unit 
×2).
5. While releasing the hook, lift the image transfer belt unit gently, and remove the image transfer cleaning unit.
6. Put toner on the image transfer belt.