HOME PAGE | < Previous | Contents | Next >
3. Insert the SD card in the storage location [A] inside the cover.
2.33.2 MOVE EXEC
1. Turn the power off.
2. SD card slot cover 
×1).
3. Set the destination SD card (SD card where data is to be stored) in Slot 1 [A], and set the original SD card (SD card from which data is to be transferred) in Slot 2 [B].
SD Card Appli Move
Installation
Installation
Installation
4. Turn the power on, and press [ENTER] in SP5-873-001 (SD Card Appli Move: Move Exec).
5. When a confirmation screen is displayed, press [ENTER] (it takes about 2 - 3 minutes).
If [CANCEL] is pressed, the display returns to the previous screen.
Note that if the power supply is turned off, a panel operation is performed, or the cover is opened during merge, it will result in a malfunction.
6. When merge is complete, and the following screen is displayed, press [CLOSE].
If the process is terminated abnormally, perform the merge in SP mode again.
If the capacity of the destination SD card is insufficient, the merge operation cannot be performed.
1. Press [END] twice.
2. Turn the power off.
3. Remove the empty SD card after transfer from Slot 2.
4. Attach the slot 
×1).
5. Turn the power on, output the system setting list, and check that the options are recognized correctly.