HOME PAGE | < Previous | Contents | Next >
2.31.3 INSTALLATION PROCEDURE
Switch the MFP’s power supply OFF, and unplug the power plug from the mains outlet.
Installation
Installation
Installation
If the battery is replaced by the wrong type, there is a danger of explosion. Dispose of used batteries according to the instructions.
1. Remove the SD card slot covers [A] and [B] 
×1)
D148/D149/D150:
D146/D147:
2. Insert the OCR module SD card in SD card slot 1 [A] or slot 2 [B].
OCR Unit Type M2
D148/D149/D150:
D146/D147:
3. Switch the power supply ON.
4. Press “Enter” in SP5-878-004 (Option Setup: OCR Dictionary).
The SD card ID is saved in the NVRAM, and the ID of the MFP is saved on the SD card. The MFP and SD card are thereby linked.
5. When “operation complete” is displayed, press "Close”.
If installation fails, "Failed" is displayed.
If installation fails, perform the following steps.
1. Check whether it is a used SD card.
2. Switch the power OFF, and repeat steps 1-5.
6. Switch the power OFF/ON.
7. Press “Enter” in SP5-878-004 (Option Setup: OCR Dictionary). Dictionary data is copied to the HDD.
On the first run, SP5-878-004 links the SD card, and on the second run, copies dictionary data.